Precor Icarian Strength Adjustable Cable Crossover
The 407B Adjustable Cable Crossover is a stand-alone cable crossover machine with two adjustable high/low pulley stations and a connector that offers dual chin-up bar options. The Crossover adjusts quickly to give users a wide range of exercise options.
PIVOT POINTS AND JOINTS – Pillow block or flange-mount motor-grade rotary bearings or sleeve bearings utilizing either oil-impregnated bronze bushings or pre-lubricated Igus nylon bushings.
WEIGHT STACK – On most selectorized units, the weight stack is elevated 5 inches to facilitate user pin selection from seated position.
FRAME AND FINISH – 11 gauge (.120″) and 7 gauge (.188″) 2×4-inch bent electroweld steel tubing. Minimum of 3 standard bolt tabs on appropriate units. Abrasive grit pre-finish is followed by electrostatically applied, heat-cured powder coat.
UPHOLSTERY – Premium-quality upholstery with Beautyguard protective topcoat finish. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Double-layer slipcover in appropriate high wear areas. Double stitching on all seams.
PULLEYS AND CABLES – Glass-fiber-reinforced nylon pulleys with precision motor-grade ball bearings. 3/16-inch (7×19) aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch coated to 3/16 inch. The cable will conform to specification MIL-W-83420D-BARE cable only. Attachments are climbing-rated carabiner design.
BEARINGS AND PIVOT POINTS – Oversized linear reticulating ball bearings are self-aligning, sealed and running on casehardened shafts.
GUIDE RODS – Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and retardation of rust.
SELECTOR PLATES – Each selector plate entirely precision machined on all surfaces. Top plate has replaceable Igus precision self-lubricating bushings. Black painted protective finish.
BOLTS – Grade 5 black zinc in most applications.
CABLE ROUTING – Wherever possible, redirection pulleys are used to route cables close to frame to minimize chance of external interference.
HANDLES – Slip-resistant rubber sleeve with machined alloy end-cap.
WEIGHT STACK STANDARD – 150 lbs / 68 kg
WEIGHT STACK HEAVY – 200 lbs / 91 kg
Equipment Dimensions and Weight
LENGTH – 176 inches / 447 cm
WIDTH – 43 inches / 109 cm
HEIGHT – 91 inches / 231 cm
EQUIPMENT WEIGHT – 870 lbs / 396 kg
FRAME: 10 years; PARTS (MECHANICAL): 5 years; WEAR ITEMS: 6 months; OTHER (INCLUDING HAND GRIPS, END CAPS, CABLES, SELECTOR PINS, SHROUDS): 1 year; LABOR: 1 year